Energy UNITS FOR LIFT TABLE

Power UNITS FOR LIFT TABLE 1
General Description
This electrical power unit is intended solely for your smaller lift table,Consisting of large pressure gear pump, AC motor, multi-functional manifold, valves, tank, etc. This power unit has become extensively applied while in the business of logistic products such as minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is controlled by the solenoid valve with all the velocity controlled through the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
Basic Description
This energy unit is designed solely for the medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve and the speed controlled by the adjustable needle valve. Once the lift rises to a high positoin, however the energy supply is lower, the decreasing movement is managed from the guide override function.
Electrical power UNITS FOR LIFT TABLE three
Basic Description
This power unit is made solely for that massive lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve along with the velocity controlled by a pressure compensated movement control valve.
Power UNITS FOR LIFT TABLE 4
Common Description
This energy unit is developed solely for the significant lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve and also the pace managed from the adjustable needle valve. When the lift rises to a higher positoin, but the electrical power provide is lower, the decreasing motion is controlled through the manual override perform.
Unique Notes
one. This power unit is of S3 duty cycle, which may only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean the many hydraulic elements concerned ahead of set up of the electrical power unit.
three. Viscosity from the oil shoud be 15~46 cst,which need to also be clean and absolutely free of impurities.N46 hydraulic oil is encouraged.
four. Oil altering is required just after the original one hundred operation hrs,afterwards once every 3000 hrs.
five. The energy unit shown is created to be mounted vertically.