SMR Gearbox Installation
Satisfactory efficiency depends upon appropriate installation. lubrication and servicing. consequently it is crucial the directions within the set up and upkeep leaflet. supplied with each and every gearbox. are followed meticulously. a few of the crucial aspects of belt and torque-arm installation are listed under.
one. Install pulley on gearbox input shaft as close on the reducer possible, and mount reducer on 
driven shaft as near to bearing as practical. failure to accomplish this can result in excess loads within the input shaft bearings and output bearings and could lead to their premature failure.
two. Install motor and wedge belt drive together with the belt pull at about 90° to your center line concerning driven and input shafts. this will likely permit tensioning in the wedge belt drive using the torque arm which should really ideally be in tension. if output hub runs anti-clockwise. torque arm must be positioned the proper.
three. lnstall torque-arm fulcrum on a rigid help to ensure the torque-arm will probably be at roughly right angles on the center line with the driven shaft along with the torque arm situation bolt. ensure that there is certainly adequate consider up in the turnbuckle for belt stress adjustment.
Maintain near.
Bell drive could possibly be positioned in any practical postion. if the torque arm is usually to be used to tighten the belts, the drive need to be at about tight angle on the line amongst the input and output shafts.
Bell drive may very well be found for the ideal if desired.
If output hub rotates clock-wise. place belt drive and torque arm in opposite route to that shown within the illustration.
Torque arm and belt get up.
Torque arm may be mounted for the suitable if preferred.
SMR Gearbox Set up
Tags